The long awaited AC motor from NetGain is here. The new 9 inch HyPer9 AC motor is based on a new high efficiency design. The motor is a permanent magnet assisted synchronous reluctance design and holds the highest efficiency rating of IE4+ at 94% motor efficiency. The motor is IP56 sealed. The matching controller, an AC-X1 by SME Group will accept a supply side DC voltage of up to 132 Volts, and will output up to 760 Amps output, with a peak 88kW of power. The permanent magnets are a new design that are manufactured without the use of rare earth elements, but still gain a big efficiency advantage with a powerful 173 lb/ft of torque. *SME Dash Display is sold separately This kit includes: HyPer 9 Motor SME AC-X1 Controller 35 Pin Connector and Wire Harness Gigavac GV200-QA Contactor 12 Volt HV Relay Motor Face: B-Face (Warp Compatible) Motor Diameter: 9.0 Inches Motor Case Length: 13.75 Inches Motor Shaft Length: 2.0 Inches Motor Shaft to End Length: 15.75 Inches Motor Type: Permanent Magnet Synchronous Reluctance AC Weight: 120 lbs Max Voltage Input: 132 Terminal Stud Size: M8 Inch Integrated Sensors: Encoder and Temperature Rated Torque: 173 Lb Ft Rated Power: 120 HP Max RPM: 8,000 RPM Sensor: Yes Drive End Shaft: 1-1/8 Inch with 1/4 Inch Keyway Accessory End Shaft: Not Available (coming soon) Max Efficiency: 0.94 Thermal Cooling: External Heatsink Max Temperature: 150 Degrees Celsius Matching Controller Included In Price: Note: Due to the excessive weight of motors additional freight charges apply. Warranty Period: 2 Years Link for Vendor Downloads Page (Start Here First)
H9 General System EV West Schematic - 72V, 96V, 120V Click Here for Motor Dimensional Drawing Click Here for CAD Models Click Here for Diagnostic Codes Click Here for Motor Dimensions Click Here for Controller Dimensions Click Here for Brake Lights on Regen or Decel Lights Click Here for the CAN Bus Setup Guide for ACX1 Click Here for the Hyper 9 Non-iso System 96V/120V - MCU - MFD15 Schematic
