This beautiful adapter will fit most 9 inch motors, Hyper9, ADC, HPEVS AC-35, Dual AC-35, AC-50, AC-51 and NEMA B Face. Very good choice when wanting to add a little flash to your conversion with this premium adapter. Built of 6061-T6 billet aluminum it comes with mounting hardware and coupler.
The coupler used in this kit is designed to work with our EV West lightweight aluminum flywheel or other Porsche 5 bolt style flywheels.This will not work with the stock VW flywheel.
Please select your application from the dropdown menu to ensure the correct mounting hardware is included with your adapter.
You can find the upgraded EV West lightweight aluminum flywheel
HERE.
NOTE:All couplers are machined to be an interference fit and must be heated on a hot plate to 600 degrees prior to installation on the motor shaft.
NOTE: If you are using this adapter with a Netgain Hyper 9 motor you must install a Hyper 9 spacer ring before installing the motor shaft coupler. If your purchased the motor through EV West one is included with the motor. If you have purchased it elsewhere you can purchase one here
HERE
Fits:
All Beetles
Aircooled Porsches (excluding 915 and some other models)
Ghias
Squarebacks
Notchbacks
Things
Vans
Pickups
Trikes
Anything using the VW Transaxle, including Kit Cars
Please contact sales@evwest.com to check fitment of your vehicle
The adapter will add 3 inches to motor length. Picture shown mounted to a Hyper 9 motor with 3 bolt chill plate.
Torque specs are as follows:
Flywheel to Shaft Coupler (M12) Steel: 60 lb/ft
Motor to Motor Adapter Plate (3/8) Aluminum: 15 lb/ft
Pressure Plate to Flywheel (M8 or 3/8) Aluminum: 15 lb/ft
Motor Adapter Plate to Bell Housing (3/8) Stainless Steel: 13 lb/ft
Dimensional Drawing to confirm this adapter fits your vehicle
